皮革科学与工程 ›› 2020, Vol. 30 ›› Issue (1): 17-22.doi: 10.19677/j.issn.1004-7964.2020.01.004

• 试验研究 • 上一篇    下一篇

铬革屑的酸碱联合处理中CaO脱铬的优化

赵胜宗1, 刘彦1, 2, *   

  1. 1.四川大学生物质与皮革工程系,四川 成都 610065;
    2.四川大学制革清洁技术国家工程实验室,四川 成都 610065
  • 收稿日期:2019-07-16 上线日期:2020-03-26
  • 作者简介:赵胜宗（1994-）,男,硕士研究生,E-mail:2757040100@qq.com。

Optimization of CaO Dechromization in Acid-base Combined Treatment of Chrome Shavings

ZHAO Shengzong1, LIU Yan1, 2, *   

  1. 1.Department of Biomass and Leather Engineering,Sichuan University,Chengdu 610065,China;
    2. National Engineering Laboratory for Clean Technology of Leather Manufacture, Sichuan University,Chengdu 610065,China
  • Received:2019-07-16 Published:2020-03-26

PDF

26

摘要： 本研究采用氧化钙对铬革屑进行脱铬处理,并对氧化钙脱铬处理的各项参数进行了优化,以达到在脱铬的同时,尽可能地减少铬革屑水解的目的。通过单因素实验,确定了各因素的最佳条件为：碱处理时间20 h,碱用量10%,碱浓度11 g/L;再通过正交实验的结果分析,得到氧化钙脱铬处理的最优工艺为：碱处理时间12 h、碱用量10%、碱浓度9 g/L和碱处理温度25 ℃。在最优工艺条件下对铬革屑进行处理后,铬革屑的铬含量为1.476 mg/g,比起始铬含量降低了94.38%,其水解率仅为14.01%。

关键词: 铬革屑, 脱铬, CaO处理, 正交实验

Abstract: In this study, the chrome shavings were dechromed by CaO, and the parameters of CaO dechroming were optimized to reduce the hydrolysis of chrome shavings as less as possible while dechroming. The single factor experiments showed that the optimal conditions for each factor were alkali treatment time 20 h, alkali dosage 10%, alkali concentration 11 g/L; and the orthogonal experiment results indicated that the optimal process for CaO dechroming was alkali treatment time 12 h, alkali dosage 10%, alkali concentration 9 g/L, and alkali treatment temperature 25 ℃. The chrome shavings have a chromium content of 1.476 mg/g, which was 94.38% lower than the initial chromium content, and the hydrolysis rate was only 14.01% by the optimal dechroming process.

Key words: chrome shavings, dechroming, CaO treatment, orthogonal experiment

中图分类号: 

网站版权©2019《皮革科学与工程》杂志社

编辑部地址：成都市一环路南一段24号四川大学皮革楼《皮革科学与工程》杂志社（610065）

本系统由北京玛格泰克科技发展有限公司设计开发